LPC Debug Port
From xboxdevwiki
| Name | Pin | Pin | Name |
|---|---|---|---|
| - | 16 | 15 | 3.3V |
| SDA | 14 | 13 | SCL |
| GND | 12 | 11 | LAD0 |
| LAD1 | 10 | 9 | 3.3V |
| LAD2 | 8 | 7 | LAD3 |
| 5V | 6 | 5 | LRESET# |
| PWR (v1.6) | 4 | 3 | LFRAME# |
| GND | 2 | 1 | LCLK |
The LPC Debug Port is an unpopulated 2x8 2.54mm (0.1") footprint on the Xbox motherboard that provides access to the system's Low Pin Count Bus, as well as the SMBus. Throughout the Xbox's lifetime, Microsoft modified the LPC port in an attempt to prevent modding and, in some cases, it must be "rebuilt" to restore the port's full functionality. Rebuilding the LPC debug port involves soldering wires between it and very small vias on the motherboard.
Pins
- 3.3V (15 & 9) - Provides 3.3V while the Xbox is powered on.
- SDA (14) - SMBus data and address signal.
- SCL (13) - SMBus clock signal.
- GND (12 & 2) - Ground.
- LAD[3:0] (11, 10, 8, 7) - LPC address and data signals.
- 5V (6) - Provides 5V while the Xbox is plugged in.
- LRESET# (5) - LPC reset signal; same as PCIRST#.
- PWR (4) - On pre-1.6 hardware, this pin does not physically exist. On 1.6 hardware, this pin is connected to the power button. Shorting it to ground will turn the Xbox on and off.
- LFRAME# (3) - LPC start-of-cycle signal.
- LCLK (2) - 33MHz LPC clock signal; same as PCICLK.
