Fatal Error
From xboxdevwiki
These are the errors which will be displayed
Checked after cold-boot, in this particular order[FIXME]:
| Value (2 digit decimal) | Step / Condition |
|---|---|
| 07 | Harddrive never left busy state (after reset from cold-boot) |
| 09 | Setting Harddrive PIO mode failed |
| 09 | Setting Harddrive DMA mode failed |
| 08 | Harddrive ATA identify device command failed |
| 09 | Harddrive is too small for cache partitions |
| 06 | Unable to unlock Harddrive |
| 08 | Harddrive ATA identify device after unlock command failed |
| 08 | Setting Harddrive device parameters failed |
| 10 | DVD Drive never left busy state (after reset from cold-boot) |
| 12 | Setting DVD Drive PIO mode failed |
| 12 | Setting DVD Drive DMA mode failed |
| 11 | DVD Drive ATAPI identify device command failed |
| 05 | Harddrive not locked; Not reported if either:
|
Additional error codes, or no precise order known[FIXME]:
| Value (2 digit decimal) | Generic meaning |
|---|---|
| 00 | No error (used internally to clear error flags from EEPROM) |
| 01 | |
| 02 | EEPROM Checksum failure |
| 03 | |
| 04 | RAM bad |
| 13 | Dashboard broken, while Kernel/LaunchDataPage reason == 0 (MainMenu)
|
| 14 | Dashboard broken, while Kernel/LaunchDataPage reason == 1 (Error)
|
| 15 | |
| 16 | Dashboard settings error[citation needed] |
| 17 | |
| 18 | |
| 19 | |
| 20 | Dashboard failed to launch, but DVD security check was successful |
| 21 | Used to manually display fatal error after reboot (on purpose) |
