JayFoxRox at 08:44, 31 May 2017

2017-05-31T08:44:00Z

Espes at 12:14, 29 May 2017

2017-05-29T12:14:44Z

Espes: Created page with " by Michael Steil (original version: 1 May 2002, updated 26 September 2002) == Seagate (10 GB) == === Harddisk information as reported by hdparm -i ===

Model=ST31021..."

2017-05-29T11:27:19Z

Created page with " by Michael Steil (original version: 1 May 2002, updated 26 September 2002) == Seagate (10 GB) == === Harddisk information as reported by hdparm -i === <pre>Model=ST31021..."

New page

by Michael Steil (original version: 1 May 2002, updated 26 September 2002)

== Seagate (10 GB) ==
=== Harddisk information as reported by hdparm -i ===

<pre>Model=ST310211A, FwRev=6.55, SerialNo=6DB2WQW2
Config={ HardSect NotMFM HdSw>15uSec Fixed DTR>10Mbs RotSpdTol>.5% }
RawCHS=16383/16/63, TrkSize=0, SectSize=0, ECCbytes=0
BuffType=unknown, BuffSize=512kB, MaxMultSect=16, MultSect=16
CurCHS=16383/16/63, CurSects=16514064, LBA=yes, LBAsects=19541088
IORDY=on/off, tPIO={min:240,w/IORDY:120}, tDMA={min:120,rec:120}
PIO modes: pio0 pio1 pio2 pio3 pio4
DMA modes: mdma0 mdma1 mdma2 udma0 udma1 *udma2
AdvancedPM=no WriteCache=enabled
Drive Supports : Reserved : ATA-1 ATA-2 ATA-3 ATA-4
</pre>
=== Detailed information as reported by hdparm -I ===

<pre>non-removable ATA device, with non-removable media
Model Number: ST310211A

Serial Number: 6DB2WQW2
Firmware Revision: 6.55
Standards:
Supported: 1 2 3 4
Likely used: 5
Configuration:
Logical max current
cylinders 16383 16383
heads 16 16
sectors/track 63 63
bytes/track: 0 (obsolete)
bytes/sector: 0 (obsolete)
current sector capacity: 16514064
LBA user addressable sectors = 19541088
Capabilities:
LBA, IORDY(can be disabled)
Buffer size: 512.0kB Queue depth: 1
Standby timer values: spec'd by standard
r/w multiple sector transfer: Max = 16 Current = 16
DMA: mdma0 mdma1 mdma2 udma0 udma1 *udma2 udma3 udma4 udma5

Cycle time: min=120ns recommended=120ns
PIO: pio0 pio1 pio2 pio3 pio4
Cycle time: no flow control=240ns IORDY flow control=120ns
Commands/features:
Enabled Supported:
* READ BUFFER cmd
* WRITE BUFFER cmd
* Host Protected Area feature set
* look-ahead
* write cache
* Power Management feature set
* Security Mode feature set
SMART feature set
SET MAX security extension
* DOWNLOAD MICROCODE cmd
Security:
supported
enabled
not locked
not frozen
not expired: security count
not supported: enhanced erase
Security level high
HW reset results:
CBLID- below Vih
Device num = 1
Checksum: correct
</pre>

=== Hard disk performance measured by hdparm -t ===

<pre>Timing buffered disk reads: 64 MB in 3.51 seconds = 18.23 MB/sec
Timing buffer-cache reads: 128 MB in 0.85 seconds =150.59 MB/sec
</pre>

== Western Digital (8 GB) ==

=== Harddisk information as reported by hdparm -i ===

<pre>Model=WDC WD80EB-28CGH1, FwRev=24.84G24, SerialNo=***************
Config={ HardSect NotMFM HdSw>15uSec SpinMotCtl Fixed DTR>5Mbs FmtGapReq }
RawCHS=15509/16/63, TrkSize=57600, SectSize=600, ECCbytes=40
BuffType=DualPortCache, BuffSize=768kB, MaxMultSect=16, MultSect=off
CurCHS=15509/16/63, CurSects=15633072, LBA=yes, LBAsects=15633072
IORDY=on/off, tPIO={min:120,w/IORDY:120}, tDMA={min:120,rec:120}
PIO modes: pio0 pio1 pio2 pio3 pio4
DMA modes: mdma0 mdma1 *mdma2
UDMA modes: udma0 udma1 udma2 udma3 udma4 udma5
AdvancedPM=no WriteCache=enabled
Drive conforms to: device does not report version: 1 2 3 4 5
</pre>

=== Detailed information as reported by hdparm -I ===

<pre>ATA device, with non-removable media
Model Number: WDC WD80EB-28CGH1

Serial Number: ***************
Firmware Revision: 24.84G24
Standards:
Supported: 5 4 3 2
Likely used: 6
Configuration:
Logical max current
cylinders 15509 15509
heads 16 16
sectors/track 63 63
--
CHS current addressable sectors: 15633072
LBA user addressable sectors: 15633072
device size with M = 1024*1024: 7633 MBytes
device size with M = 1000*1000: 8004 MBytes (8 GB)
Capabilities:
LBA, IORDY(can be disabled)
bytes avail on r/w long: 40 Queue depth: 1
Standby timer values: spec'd by Standard, with device specific minimum
R/W multiple sector transfer: Max = 16 Current = 0
Recommended acoustic management value: 128, current value: 254
DMA: mdma0 mdma1 *mdma2 udma0 udma1 udma2 udma3 udma4 udma5

Cycle time: min=120ns recommended=120ns
PIO: pio0 pio1 pio2 pio3 pio4
Cycle time: no flow control=120ns IORDY flow control=120ns
Commands/features:
Enabled Supported:
* READ BUFFER cmd
* WRITE BUFFER cmd
* Host Protected Area feature set
* Look-ahead
* Write cache
* Power Management feature set
* Security Mode feature set
* SMART feature set
Automatic Acoustic Management feature set
SET MAX security extension
* DOWNLOAD MICROCODE cmd
Security:
supported
enabled
not locked
not frozen
not expired: security count
not supported: enhanced erase
Security level high
HW reset results:
CBLID- above Vih
Device num = 0 determined by CSEL
Checksum: correct

</pre>
=== Hard disk performance measured by hdparm -t ===

<pre>Timing buffered disk reads: 64 MB in 6.58 seconds = 9.73 MB/sec
Timing buffer-cache reads: 128 MB in 3.28 seconds = 39.02 MB/sec
</pre>

Retrieved from [http://www.xbox-linux.org/wiki/Xbox_Hard_Disk_Technical_Details]

← Older revision		Revision as of 08:44, 31 May 2017
Line 1:		Line 1:
−	~~Retrieved from [~~http://www.xbox-linux.org/wiki/Xbox_Hard_Disk_Technical_Details]	+	{{retrieved\|http://www.xbox-linux.org/wiki/Xbox_Hard_Disk_Technical_Details\|ours=Hard Drive}}

Xbox Hard Disk Technical Details - Revision history

JayFoxRox at 08:44, 31 May 2017

Espes at 12:14, 29 May 2017

Espes: Created page with " by Michael Steil (original version: 1 May 2002, updated 26 September 2002) == Seagate (10 GB) == === Harddisk information as reported by hdparm -i ===
Model=ST31021..."

@@ Line 1: / Line 1: @@
+Retrieved from [http://www.xbox-linux.org/wiki/Xbox_Hard_Disk_Technical_Details]
 by Michael Steil (original version: 1 May 2002, updated 26 September 2002)
@@ Line 157: / Line 159: @@
 Timing buffer-cache reads:   128 MB in  3.28 seconds = 39.02 MB/sec
 </pre>